Air Thick Film Heater Many Ways To Achieve Energy Efficiency Goals

Air Thick Film Heater Many ways to achieve energy efficiency goals
In the absence of any energy-saving measures, the use of air Thick Film Heater naturally can not reflect the energy-saving side, in order to achieve energy-saving goals, you can improve the structure of the Thick Film Heater, adjust its parameters, etc., I believe that the effect of change Is also obvious.
A large portion of the user is using the air Thick Film Heater to heat the pipe at the exit of the Thick Film Heater without any insulation on the surface of the Thick Film Heater itself. But there is data to prove that in the air Thick Film Heater surface to increase the insulation layer can reduce a lot of energy consumption.
So to remind the majority of people Thick Film Heater users, in the equipment pipeline to install insulation layer at the same time, do not forget the air Thick Film Heater itself to install insulation layer. This long-term operation, saving energy consumption is very impressive, can reduce the operating costs of equipment.
General air The thickness of the Thick Film Heater is determined by the calculation of the air volume and the temperature rise. Therefore, the air volume and the temperature rise have been satisfied. It is not advisable to use excessive air volume and excessive temperature rise. Otherwise, it may lead to heating The power of the device is too large to increase the energy consumption. So, rational design, to determine the appropriate parameters is very critical.
When the need for heated air through the air inside the Thick Film Heater, to produce pressure loss, and the greater the pressure loss, the greater the energy consumption of the fan. Therefore, it should be improved from the structure of the air Thick Film Heater itself, so that the resulting pressure loss is reduced as much as possible, thus benefiting from the realization of energy saving.
Auxiliary Thick Film Heater is a stainless steel heating equipment, in addition to the excellent performance brought by stainless steel, there are small size, waterproof design reasonable advantage. In addition to the auxiliary Thick Film Heater between the outer bladder and the liner with a thermal insulation design, can avoid the loss of heat in the course of work.
In the auxiliary electric heating water aspects of the design, make full use of the golden point, to ensure that it can fully reflect the high heating efficiency, no high and low temperature advantages. After a series of test pressure test, formal, high standard and strict requirements of the auxiliary Thick Film Heater's pressure capacity reached the national standard for small pressure vessels.
Auxiliary Thick Film Heater temperature control system and overheat protection system all use the domestic advanced components, high agility, high efficiency, so that the auxiliary heater in the process of work, you can save energy, to avoid product damage. When installing the auxiliary Thick Film Heater, it is usually installed in parallel to the outlet of the pipeline, to play its function.
Its function is in the low temperature of the cold area as an auxiliary heat source equipment used to prevent the heat pump heating capacity and heating performance coefficient of the problem. As the auxiliary Thick Film Heater does not require any other auxiliary equipment, so it is in the installation, operation, maintenance than the use of small boilers and other equipment compared to a clear advantage.
After the installation of the auxiliary Thick Film Heater can be integrated with the central air conditioning unit, the use of the unit can be achieved with the linkage control, preheating of circulating water to improve the water temperature, both to ensure that the air conditioning unit start and run the normal, but also improve the air conditioning The heating efficiency of the unit and the heating effect.
And then look at its energy consumption, although the auxiliary heating itself will be better, but this can improve the efficiency of the central air conditioning unit heating operation to get some compensation, so the total power consumption is not obvious.